Village of Johnsburg (IL)

Illinois Authority Having Jurisdiction Solar permitting requirements

NEC Code Version2014

Fire Code Version2015 Building Code

SolarAPP+ StatusTargeted

Wet Stamps RequiredDigital Structural

Fire Setback Enforced1

Codes

NEC Code Version: 2014

Fire Code Version: 2015 Building Code

Code List

2015 INTERNATIONAL BUILDING CODE

2015 INTERNATIONAL ENERGY CONSERVATION CODE

2015 INTERNATIONAL FUEL GAS COE

2015 INTERNATIONAL MECHANICAL CODE

2015 INTERNATIONAL PROPERTY MAINTENANCE CODE

2015 INTERNATIONAL RESIDENTIAL CODE

2015 INTERNATIONAL FIRE CODE

2014 NATIONAL ELECTRIC CODE

2014 STATE OF ILLINOIS PLUMBING CODE

1997 ILLINOIS ACCESSIBILITY CODE

ASCE Code Specification: ASCE 7-16

SolarAPP+ & submittal

SolarAPP+ Status: Targeted

Any SolarAPP+ Restrictions: 1

SolarAPP+ Restrictions: MPU,Derate,Derate

Revision Required: 0

New Planset Required For Module Swap: 0

Stamps

Ee Stamp Required On SLD: No

Wet Stamps Required: Digital Structural

Structural Calculations Required: Yes

Fire setbacks

Fire Setback Enforced: 1

Structural & loads

Wind Speed: 90

Snow Load: 20

Reducible Snow Load Allowed: 1

Minimum Ground On Roof: #10

Electrical

Electrical Load Calcs Required: Derates

Allowed POI: Line Side Taps,PV Breaker,Load Side Taps,Meter Adapter

Temperature Rating: 90

De Rating Ampacity: 0.91

BOS Restrictions: Standard

Battery / ESS

Unique Battery Placards Needed: 0

ESS Elevation Detail Required: No

Plan set

Plan Set Requirements: Building elevation required showing total building height with panels included

Cover Page

Standard

Provide the Distributed Generation Certificate for the installer LLC IRC 106.1

Cover Page Notes

Crimp on terminals shall be listed and installed using a listed tool specified for use in crimping those specific crimps. (NEC 110.3 )

Twist on wire connectors shall be listed for the environment (i.e., wet, damp, etc.) and shall be installed per manufacturer’s installation instructions. NEC 110.11

Photovoltaic Modules shall not be installed over any attic, plumbing or mechanical vent. Plumbing vents to extend a minimum of 12 inches above roof or modules. No building, plumbing or mechanical vents are to be covered, obstructed, or routed around modules. IRC 106.1

Site: Indicate if and how any conduit to be run through the attic will be installed and secured.

Roof Plan: Indicate if and how any conduit to be run through the attic will be installed and secured.

Attachment Detail: Standard

Electrical Diagram

Standard

Provide a photo of the existing main service panel with the cover off. IRC 106.1

Provide a photo of the existing Com Ed meter. IRC 106.1

Label Page: Standard

Ground mount

Ground Mount Fencing Required: Mesh/Scrim

Setback Front Yard: 5

Setback Back Yard: 5

Setback Side Yard: 5